<code id="padct"><ol id="padct"></ol></code>
    <td id="padct"><ruby id="padct"></ruby></td>
    <pre id="padct"></pre>
  • <track id="padct"><ruby id="padct"></ruby></track>

    1. <acronym id="padct"></acronym>

      CN ???ENGwelcome to the official website of Su Zhou United machine co.,ltd

      50 years focused on

      High tech enterprises. Horizontal screw centrifuge strength manufacturers

      0512-65657076

      139-0620-3239

      Location:首页>>News>>Industry News

      Product line

      National Service Hotline

      0512-65657076

      Centrifuge automatic parking system

      Time:2021-06-21 08:30:45  Clicks:73

      Centrifuge automatic parking system
      What is the reason for the automatic shutdown of centrifugal machine?
      1、Common faults of electrical equipment. If this condition is judged, it is necessary to quickly contact the electrical equipment maintenance personnel to carry out inspection and treatment on part of the electrical equipment.
      2、The overheating of the motor makes the thermal safety protector jump off, which may also cause the centrifuge to stop. At this time, it is necessary to contact the maintenance personnel as soon as possible.
      3、The excessive slurry volume makes the torque arm manipulator automatically release the full automatic safety protection workers' operation efficiency, which may lead to the centrifuge shutdown. At this time, the operator should rotate the torque arm clockwise. If there is no obstruction, cover the torque arm, drive from the beginning, and adjust the feed amount; If there is any obstruction, remove the small bearing end cover, wash the rotating drum with tap water, and rotate the drive belt at the front and rear left and right until it is determined that there is no running material rotation in the rotating cylinder, and then drive from scratch. It can also check whether the discharging port of centrifuge is blocked by raw materials according to the situation on the spot. If the blockage is serious, it will cause the machine equipment load to be very large, which may lead to the centrifuge automatic parking system. At this time, the material cutting port shall be cleaned immediately, the running material shall be cancelled, and the rotating cylinder shall be removed. It is confirmed that the driving can be started from scratch after cleaning.


      Home Tel Contact
      人妻精品丝袜一区二区无码AV
      <code id="padct"><ol id="padct"></ol></code>
      <td id="padct"><ruby id="padct"></ruby></td>
      <pre id="padct"></pre>
    2. <track id="padct"><ruby id="padct"></ruby></track>

      1. <acronym id="padct"></acronym>